Fujitsu PRIMERGY RX300 S7, Operating Manual

Page: 75 / 90

RX300 S7
Operating Manual 75
Starting up and operation
6.2 Switching the server on and off
V
CAUTION!
●
If nothing appears on the screen but flickering stripes after switching
on the server, switch the server off immediately (see chapter
"Troubleshooting and tips" on page 85 ).
●
The On/Off button does not disconnect the server from the mains
voltage. To completely disconnect it from the mains voltage, remove
the power plug(s) from all PSU inlet connectors.
●
Do not move, strike, or shake the server when it is turned on. This can
damage the hard disk in the server and cause data loss.
●
Turn the server on when the temperature is within its operating
environment range (10–35°C). For details on the operating
environment, refer to "Safety Precautions". When operating the
device outside of this operating environment, the server may operate
improperly and data loss may occur. Furthermore, Fujitsu cannot be
held responsible for any related damage, malfunction, or loss of data,
etc.
●
Be sure to wait for 10 seconds or more after shutdown before turning
the server on again.
●
After connecting all power cords, wait at least 10 seconds before
pressing the On/Off button.
Switching the server on
The Power-on indicator lights up orange (standby mode) when the server is
connected to the mains.
I
The controls and indicators are shown in figure 6 on page 63 .
– Starting up for the first time:
For the Japanese market, please refer to "
はじめにお読みください
".
Ê
Press the On/Off button.
Ê
Insert ServerView Suite DVD 1 in the DVD drive.