Fujitsu PRIMERGY RX200 S6, Operating Manual

Page: 54 / 126

54 Operating Manual
RX200 S6
Hardware installation
Ê Fasten the server to the rack (5) using the two knurled screws (front panel).
Ê Route the cables as described in the technical manual for the rack in
question with the server pushed in.
4.2.3 Installation in 3rd party racks
I
The support systems from Fujitsu are suitable for use in any 3rd party
racks for standard servers (installation depth 714 - 785 mm) without
restrictions.
Ê
Refer to the manual from the rack manufacturer for details of the mechanical
installation and the climatic conditions.
V
CAUTION!
When installing in 3rd party racks, it must be ensured that an air flow
from the front to the back of the rack is guaranteed.
Ê Fit the required original parts (support bracket or cable management
system).
I
Under certain circumstances, you will not be able to use some of the
parts from the rack installation kit supplied - you will need to use
original 3rd party rack parts instead.
Racks with installation depth of 735 mm
The lengths of the telescopic rails do not need to be adjusted with respect to
each other for the installation in rack systems with 735 mm installation depth.
Ê
Secure the support systems as described in section "Installing the support
systems" on page 51 .
Ê Mount the server (see "Preparing the server" on page 52 ) and route the
cables as described in the original manual of the rack..
V
CAUTION!
Ensure that the safety lock has been inserted before the server is
inserted (see
figure 5 on page 51 ).