Fujitsu M304X series, Oem Manual

Page: 66 / 143

Start code
VFU data Stop code
I I
Data Bit I
Data Bit 8
Data Strobe
Note:
The Busy signal is st to ech time an FCB data byte is received
during a sequence between the start and stop codes.
Figure 5.7 FCB data receive timing chart
5.2.2 Physical specifications of interface signals
The physical specifications of Centronics-interface signals consist of
electrical specifications, interface cable specifications, and connector pin
assignment specifications.
(1) Electrical specifications
Signal levels must be within the following ranges:
Low 0.0 to v
High to V
Note: The signal level above are at the interface connector.
Incorrect signals may be issued at power-on and power-off.
The interface signal driver and receiver must be the same as those shown
in Figure 5.8.
5 - 8