Fujitsu M304X series, Oem Manual

Page: 49 / 143

If the data code expressed by to WIF8 is or when
the Paper Instruction signal is 1,
the printer treats the data code as the
start code for FCB data loading and loads into the FCB the data following
the start code, until the printer receives the stop code
The stop
code is sent with the Paper Instruction signal.
The transferred data is first loaded into the print data buffer in
the IBF. Then the interface control microprogram loads the data
into the FCB and knows the number of lines per page by counting the loaded
FCB
data
bytes.
Table 4.3 shows the definition of the start code.
Table 4.3 Definition of the start code
Code
Operation
8 7 6 5 4 3 2 1
0 1 1 0 1 1 0 0 6 C
Line spacing is 6
Six eight specification from
0 1 1 0 1 1 0 1 Line is 8 lpi.
panel ignored.
0 1 1 0 1 1 1 0 are fed in lpi when specified the operator panel.
Note: WIF8 is ignored and treated as 0 in 7-bit mode.
In Figure 4.8, (2 is the format control FCB
data.
Each L or H is one byte of data.
Each pair an L and H is format
control data for one line on the form.
is data for line 1, is
data for line 2, and forth. is data for the last line, and
indicates the total
number
of lines on a form (page.).
The first byte
of the 2-byte line format data specifies a channel from 1 to 6 and
the second byte specifies a channel number from 7 to 12.
Figure 4.9
shows the correspondence between channels and to WIF8.
Data L
Data H
signals
Specified
channel
8
6 4 3
2 1
6
5 4 1
Note:
X do not care. (In 8-bit mode)
Figure 4.9 Correspondence between FCB data channels and bits
4 13