Fujitsu Lifebook B112, User Manual, Page: 122 / 174

S e c t i o n F i v e
108
6. When the card is installed, lock it in place
by sliding the lock button to the right.
(See Figure 5-8.)
Removing a PC Card
If you wish to remove or replace the PC Card,
use the following procedure:
1. Shutdown operation of the card.
2. Click on the PC Card indicator on the
Windows taskbar.
From the PC Card Properties Window:
3. Select the card to be removed and click
on the Stop button.
4. Verify that the
You can safely remove
your card
message appears.
5. If the
device cannot be removed
message appears, save all files, close all
applications, and exit Windows 98 and
then shutoff the power with the power
switch. (See Power Off on page 16.)
6. Slide the lock toward the rear of your
notebook to release the card.
SERIAL PORT DEVICES
To connect an RS-232C device to the serial
port, be sure that the connector is the right size
and aligned, then push in until it is fully seated.
When it is seated tighten the hold-down
screws, one on each end of the connector.
(See Figure 1-11 on page 8.)
USB MOUSE & DEVICES
Make sure the USB connector on the mouse is
the correct type. Align the arrow on the con-
nector to point to the bottom of your notebook
and push it in until the connector seats. A
mouse may be installed and automatically rec-
ognized by your notebook without restarting
or changing setups. (See Figure 1-7 on page 6.)
When installing a device on the USB Port, be
sure that the connector is the right size, aligned,
and fully seated. (See Figure 1-7 on page 6.)
MICROPHONE
Make sure that your mono microphone is
equipped with an 1/8" (3.5 mm) mono
mini-plug. Make sure the plug is aligned
and push it into the jack until fully seated.
(See Figure 1-7 on page 6.)
C A U T I O N
If the PC Card has an external connector
and cable, do not pull on this cable when
removing the card.
7. Flip the eject button toward the rear of your
notebook until it is fully extended.
8. Press the eject button in until it is flush with
the side of your notebook.
9. Grasp the card and pull it clear of
your notebook. (See Figure 5-8.)
PARALLEL PORT DEVICES
To connect a parallel interface device to the par-
allel port, be sure that the connector is the right
size and aligned, then push in until it is fully
seated. When it is seated tighten the hold-down
screws, one on each end of the connector. (See
Figure 1-11 on page 8.)