Fujitsu LAN Console, Installation, Configuration And Operation

Page: 52 / 139

46
U41224-J-Z916-1-76
Configuring the LAN Console and RCA Configuration
The information on the network and RCA listed at the beginning of section
“Commands” on page 43 is needed for this. The RCA ports
(TCP_PORT_300x) have to be selected in keeping with the configuration
entries created under the section “Configuring the LAN Console” on
page 43.
As described under “BOOTP service for RCA” on page 48, the content of the
work file is analyzed by a shell and loaded, i.e. the entries must comply with
the shell syntax rules (e.g. values must follow straight after the “=” charac-
ter). Syntax and/or plausibility errors are reported and cause the script to ter-
minate.
I
As usual in the shell, comments are preceded by “#”.
Template file /opt/SMAW/SMAWxsco/misc/setup.tpl
# Configuration Template for RCAs setup.ini
#
# fill in like:
KEY=value
# ethernet address: 6 2-digit hex values separated by a
#
colon (00 - FF)
# ip address: 4 numeric values separated by a dot
# (0 - 255)
#
_____________________________________________________________
#
#
# RCAs network configuration
#
RCA_MAC=
# ethernet (HW) address of RCA
(08:00:06:0a:f4:0b)
RCA_IP= # ip address of RCA (129.103.165.66)
RCA_Netmask= # ip netmask of RCA (255.255.255.0)
RCA_IP_Name= # host name of RCA (akkord)
RCA_Domain= # domain suffix (pdb.siemens.de)
RCA_Gateways= # no / yes (default no) (0 | 1)
RCA_Use_DNS= # no / yes (default no) (0 | 1)
#
#
_____________________________________________________________
#
#
# if using gateways : address of 1st gateway
#
RCA_Gateway_IP=
# ip address of RCAs gateway (129.103.165.1)
#
#
_____________________________________________________________
#