Fujitsu ETERNUS DX60 S3, Configuration Manual

Page: 30 / 160

2.2 Controller Enclosure Installation (for Regions Other than
EMEA&I)
This section describes how to install the controller enclosure in a rack.
1
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance between the front and
rear rack pillars. Leave the M4 screws slightly unscrewed, as the rack rails must be attached to the rack
before they can be completely tightened.
Loosen the M4 screws to
adjust the length of the
rack rails to match the
distance between the
front and rear rack pillars.
(Rack pillar: front)
(Rack pillar: rear)
Rack rail (right)
An "R" mark is on the inner side.
[Left]
[Right]
Rack rail (left)
An "L" mark is on the
inner side.
2
Attach the rack rails to the rack.
Use the two plates to fasten the rack rails to the front rack pillars. Use the washers to fasten the rack
rails to the rear rack pillars.
Chapter 2 Rack Installation
2.2 Controller Enclosure Installation (for Regions Other than EMEA&I)
30
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0