Chapter 9
Advanced Copy Settings
This chapter explains the required setting to perform an Advanced Copy. This chapter also provides a proce-
dure on how to perform an Advanced Copy.
9.1
Advanced Copy Basic Settings
This section describes the basic settings to use Advanced Copy.
9.1.1
Copy Priority Settings
Specify the copy priority when using the EC and OPC (*1) functions.
To set the copy priority, the host I/O load and the copy processing load must be taken into consideration. The
specified copy priority is applied not only to the next session, but also to the existing session.
*1:
An OPC includes OPC, QuickOPC, SnapOPC, and .
1
Click the [Advanced Copy] tab on the navigation of the ETERNUS Web GUI screen. Then, click [Setting]
in [Category].
2
In [Action] on the [Setting] screen, click [Modify EC/OPC Priority].
3
Select the EC/OPC priority and click the [Set] button.
•
Automatic Priority
This mode changes the EC/OPC priority automatically in response to the operating load status.
•
High Priority
This mode operates by making maximum use of internal resources.
This mode greatly affects host access performance, thus should not be used during normal operation.
Use when the operation load is low.
•
Middle Priority
This mode operates slightly slower than the High Priority mode.
Select this mode when performance is greatly affected by the High Priority mode, but the copy speed
is too slow with the Low Priority mode.
•
Low Priority
This mode reduces the effect on host access.
Select this mode when using EC and/or OPC during operation.
•
Very Low Priority
This mode operates slower than the Low Priority mode.
137
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0
Summary of Contents for ETERNUS DX60 S3
Page 2: ...This page is intentionally left blank ...
Page 160: ......
