Fujitsu DVD Player, User Manual

Page: 61 / 108

51
U s e r I n s t a l l a b l e F e a t u r e s
Memory Upgrade
Module
Your Fujitsu LifeBook notebook comes with 128MB or
256MB high speed Synchronous Dynamic RAM
(SDRAM) factory installed. To increase your notebook’s
memory capacity, you can replace the original memory
module with a higher capacity module. The memory
upgrade must be a dual-in-line (DIMM) SDRAM
module, and it can be up to 256MB capacity.
INSTALLING A MEMORY UPGRADE
MODULE
1. Turn off power to your LifeBook notebook using the
power switch, and remove any power adapter
(AC or auto/airline).
2. Make sure that all the connector covers are closed.
3. Turn the notebook bottom side up, with the front
panel toward you.
4. Remove the screws of the memory upgrade module
compartment. (Figure 4-9)
5. Remove the cover.
Figure 4-9 Opening the Memory Upgrade Compartment
6. Remove the memory upgrade module from the
static guarded sleeve.
7. Align the memory upgrade module with the part
side up. Align the connector edge of the memory
upgrade module with the connector slot in the
compartment. The connector will be pointing
toward the rear of the notebook.
8. Insert the memory upgrade module at a 45° angle.
Press the connector edge of the module firmly down
and into the connector until it lodges under the
retaining clip. You will hear a click when it is prop-
erly in place. (Figure 4-10)
Figure 4-10 Installing a Memory Upgrade Module
9. Replace the cover.
10. Replace the screws.
TO REMOVE A MEMORY UPGRADE MODULE
1. Perform steps 1 through 5 of Installing a Memory
Upgrade Module.
2. Pull the clips sideways away from each side of the
memory upgrade module at the same time.
3. While holding the clips out, remove the module
from the slot by lifting it up and pulling towards the
rear of your notebook. (Figure 4-11)
Figure 4-11 Removing a Memory Upgrade Module
4. Store the memory upgrade module in a static
guarded sleeve.
5. Replace the cover.
6. Replace the screws.
C A U T I O N S
■
Do not remove any screws from the memory upgrade
module compartment except the ones specifically
shown in the directions for installing and removing
the memory upgrade module.
■
The memory upgrade module can be severely dam-
aged by electro-static discharge (ESD). Be sure you
are properly grounded when handling and installing
the module.
P O I N T
The memory upgrade module is not something you
routinely remove from your notebook. Once it is
installed, you can leave it in place unless you want
to change system memory capacity.
S Series.book Page 51 Friday, April 20, 2001 5:16 PM