Fujitsu D1837, Technical Manual

Page: 45 / 48

Error messages
36 - English
A26361-D1837-Z120-1-7419, Edition 1
Keyboard error nn
nn Stuck Key
Release the key on the keyboard ( nn is the hexadecimal code for the key).
Missing or invalid NVRAM token
Switch the device off and on again. If the message is still displayed, please contact your sales
outlet or customer service centre.
Monitor type does not match CMOS - RUN SETUP
Correct the entry for the monitor type in the
Main
menu of the
BIOS Setup
.
On Board PCI VGA not configured for Bus Master
In the BIOS Setup , in the Advanced menu, submenu PCI Configuration , set the Shared PCI Master
Assignment entry to VGA .
One or more RDRAM devices are not used
One or more RDRAM devices have bad architecture/timing
One or more RDRAM devices are disabled
Contact your system administrator or contact our customer service centre.
Operating system not found
Check the entries for the hard disk drive and the floppy disk drive in the
Main
menu and the
entries for
Boot Sequence
submenu of the
BIOS Setup
.
Parity Check 1
Parity Check 2
Switch the device off and on again. If the message is still displayed, please contact your sales
outlet or customer service centre.
Previous boot incomplete - Default configuration used
By pressing function key F2 you can check and correct the settings in BIOS Setup . By
pressing function key F1 the system starts with incomplete system configuration. If the
message is still displayed, please contact your sales outlet or customer service centre.
Real time clock error
Call the
BIOS Setup
and enter the correct time in the
Main
menu. If the message is still
displayed, please contact your sales outlet or customer service centre.
System battery is dead - Replace and run SETUP
Replace the lithium battery on the mainboard and redo the settings in the BIOS Setup .
System Cache Error - Cache disabled
Switch the device off and on again. If the message is still displayed, please contact your sales
outlet or customer service centre.
System CMOS checksum bad - - Default configuration used
Call the
BIOS Setup
and correct the previously made entries or set the default entries.