NAS maintenance
Fujitsu
53
Resetting the administrator password and network
settings
To reset the administrator password and NAS network settings, proceed as follows:
►
Press and hold the Reset button on the NAS for 3 seconds. A beep will be heard. This will reset
the following settings to their defaults:
–
System administration password: admin
–
TCP/IP configuration: Obtain IP address settings automatically via DHCP
– TCP/IP
configuration: Disable Jumbo Frame
–
TCP/IP configuration: If port trunking is enabled (dual LAN models only), the port trunking
mode will be reset to “Active Backup (Failover)”.
–
System Port: 8080 (system service port)
–
Security Level: Low (Allow all connections)
–
LCD panel password: (blank)
–
VLAN will be disabled
Advanced system reset (10 sec)
►
Press and hold the Reset button for 10 seconds.
Two beeps sound (after the third and tenth seconds). The NAS will reset all the system settings to
default as it does by web-based system reset in
Control Panel - System Settings - Backup / Restore -
Restore to Factory Default
except all the data are reserved. The settings such as the users, user
groups, and the network share folders previously created will be cleared. To retrieve the old data
after the advanced system reset, create the same network share folders on the NAS and the data will
be accessible again.
►
Log in to the NAS with the default user name and password:
–
Default user name:
admin
– Password:
admin
i
The
Enable configuration reset switch
option must be enabled in
Control Panel - System
Settings
-
Hardware
in order to allow the system to be reset to defaults using the reset
button.
Summary of Contents for CELVIN NAS QE705
Page 1: ...Operating Manual System CELVIN NAS ...
Page 3: ......