Fujitsu AOCG040LBTA, Service Instruction

Page: 64 / 67

03-05
(2) Press the button for more then 5 seconds.
(4) Press the button. (Return to normal display)
Custom code setting for remote controller
(3) Press the ( ) ( ) buttons to change the signal code between .
Match the code on the display to the air conditioner signal code. (initially set to )
If you change the setting of Fanction Number and Setting Value
after setting custom code in remote controller, please set custom
code in remote controller again.
The remote control unit resets to signal code A when the batteries in
the remote control unit are replaced. If you use a signal code other
than signal code A, reset the signal code after replacing the
batteries.
If you do not know the air conditioner signal code setting, try each
of the signal codes ( ) until you find the code which
operates the air conditioner.
CAUTION
(1) Press the / button until only the clock is displayed on the remote controller display.
Use the following steps to select the signal code of the remote controller.
(Note that the air conditioner cannot receive a signal code if the air conditioner
has not been set for the signal code.)