Fujitsu AD11, Manual

Page: 46 / 64

3 - 10
AD11 Mainboard Manual
AGP Fast Write
When set at Enabled, this feature allows user to set AGP fast write made.
The options are: Enabled, Disabled
AGP Data Transfer Mode
This feature allows you to select the AGP slot data transfer mode. If you
AGP card is of 1x or 2x, please set at 1x/2x.
The options are: 1x/2x, 4x.
K7 CLK_CTL Select
This item allows users to set K7 CPU clock ramp rate according to the
system clock multiplier (CLKMUL) and the system bus speed.
The options are: Default, Optimal.
SDRAM ECC Setting
This feature allows user to select the ECC types if the on slot SDRAM
supports it.
The options are: Disabled, Check Only, Correct Errors, Scrub.
Super Bypass Mode
When enable it, North Bridge core chip will internally bypass certain memory
to CPU pipe stages. The options are: Enabled, Disabled.
SDRAM Timing setting by
When set at Manual, the features below will be ready for your setting.
The options are: Auto, Manual.
SDRAM PH Limit
The feature allows user to set the number of consecutive Page Hit (PH)
requests to allow before choosing a non PH request.
The options are: 1 Cycle, 4 Cycle, 8 Cycle, 16 Cycle.
SDRAM Idle Limit
The feature allows user to set the number of idle cycle to wait before
precharging and idle bank. Idle Cycles - cycles that no valid requests are
asserted to the MCT. The options are: 0, 8 Cycle, 12 Cycle, 16 Cycle, 24
Cycle, 32 Cycle , 48 Cycle, Disabled.