S e c t i o n F o u r
126
C A U T I O N
If the PC Card has an external connector
and cable, do not pull on this cable when
removing the card.
STEREO LINE IN DEVICE
Make sure that your stereo line in audio device,
a cassette recorder, for example,is equipped
with an 1/8" (3.5 mm) stereo mini-plug. Make
sure the plug is aligned and push it into the jack
until fully seated. (See Figure 1-8 on page 8.)
HEADPHONES
Make sure that your stereo headphones are
equipped with an 1/8" (3.5 mm) stereo mini-
plug. Make sure the plug is aligned and push
it into the jack until fully seated.
(See Figure 1-8 on page 8.)
SERIAL PORT DEVICES
To connect an RS-232C device to the serial
port, be sure that the connector is the right size
and aligned,then push in until it is fully seated.
When it is seated tighten the hold-down screws,
one on each end of the connector.
(See Figure 1-9 on page 9.)
USB DEVICES
When installing a device on the USB Port, be
sure that the connector is the right size,aligned,
and fully seated. (See Figure 1-8 on page 8.)
P O I N T
Plugging in headphones disables the
built-in stereo speakers.
4. Verify that the
You can safely remove
your card
message appears.
5. If the
device cannot be removed
message appears, save all files, close all
applications, and exit Windows 95 then shut-
off the power with the power switch.
(See Power Off on pages 24-25.)
C A U T I O N
Due to ongoing changes in USB technology
and standards not all USB devices and/or
drivers are guaranteed to work.
PARALLEL PORT DEVICES
To connect a parallel interface device to the par-
allel port, be sure that the connector is the right
size and aligned,then push in until it is fully
seated. When it is seated tighten the hold-down
screws, one on each end of the connector.
(See Figure 1-9 on page 9.)
MICROPHONE
Make sure that your mono microphone is
equipped with an 1/8" (3.5 mm) mono
mini-plug. Make sure the plug is aligned
and push it into the jack until fully seated.
(See Figure 1-8 on page 8.)
