Fujitsu Siemens Computers PRIMERGY SX30, Operating Manual

Page: 36 / 101

36
U41169-J-Z156-4-74
Power Supply Units Power Supply
5.1.1 Replacing the Power Supply Unit
V
CAUTION!
It is imperative that you read the chapter chapter “Important Notes” on
page 13 in this manual before you carry out work on your storage
subsystem.
If faults occur with the power supply unit, it could be necessary to replace a
power supply unit. Information about the relevant error messages can be found
in the sections
“Meaning of the Operating Status LEDs” on page 22 and “Power
Supply Unit LEDs” on page 28 and in the chapter chapter “Fault Clearing” on
page 85 .
Figure 12: Power Supply Unit Removed
V
CAUTION!
When a power supply unit is replaced in a non-redundant power supply
system (only one power supply unit present) the server must be
switched off or the SCSI channels deactivated.
Ê If only one power supply unit is present, shut down the server and switch it
off.
Ê Remove the lead of the defective power supply unit.
Ê
Raise the lower catch on the power supply unit and carefully remove it from
its slot by pulling on the upper catch. To remove the power supply unit the
lower catch must be in the up position.