78
U41169-J-Z156-4-74
Installing in the Different Racks
Installation
11.7
Installing in the DataCenter Rack
The installation in the DataCenter Rack is carried out in the same way as was
described for the PRIMECENTER Rack.
11.8
Installing in the Classic Rack
To install the server in the Classic (19-inch) Rack, please use a sliding rail of the
rack manufacturer.
The rack mounting kit delivered with the server cannot be used for this rack.
11.9
Installing in 3rd-Party Racks
If your rack matches the general conditions for 3rd-Party Racks, you can use
parts of the rack mounting kit delivered with the server. The delivered support
bracket and the cable management may not be required.
For installing the server in a 3rd-Party Rack the following parts from the rack
mounting kit are required:
–
Two telescopic rails (assembled)
–
Eight mounting springs with Tapetite II M4 screws.
Ê
Refer to the original manual of the rack manufacturer regarding the
mechanical installation and/or the climatic conditions.
V
When installing the server installation in 3rd-Party Racks, make sure
that there is air flow in the rack from the front to the rear.
I
A number of parts of the delivered rack mounting kit may not be
compatible, because original parts of the 3rd-Party Rack must to be
used.
V
Make sure that the server security mechanismus, e. g. stoppers and
holding back systems, will function properly.
Ê
Insert the server (see
section “Installing the Server” on page 79
).
Ê
Route the cables as described in the original manual of the rack.
Ê
Secure the server on the front panel using two knurled screws.
