Converting a tower server into a rack server
A26361-K482-Z121-2-7419
English - 13
Depending on the design of the bottom tray (open or closed at rear) and the planned cable routing
(articulated cable carrier or cable chain), there are three different versions for fixing the server to the
bottom tray at the back:
1
2
a
Ê
If the bottom tray is closed at the rear, then use the small bottom angle piece shown and two
Torx M4 screws to fix the server on the bottom tray at the rear (1 + 2). The oblong hole (a)
must face the bottom tray when doing so.
1
2
1
Ê
If the bottom tray is open at the rear, and you want to use the articulated cable carrier for cable
routing, then use the wide bottom angle piece shown and three Torx M5 screws (1) and one
Torx M4 screw (2) to fix the server to the bottom tray at the rear. In this case the bottom tray is
completely closed off at the rear.
