AL-MEISTER ALM3222 Instruction Manual <Rev.2>
Page
27
of
63
4. SET LAMINATION FILM/MANUAL MODE (cont’d)
If the threading card and film do not emerge from the discharge
within 5 seconds
pull the threading back out
of the nip and repeat the threading process from step 6.
If the machine is not threaded properly damage to
interior components will occur.
15. After most of the threading card and film web emerge from the discharge lower the Lamination Handle.
STOP! Do not go any further until the READY light is on AND the machine is fully heated.
16. It is very important to run the machine in “manual mode” (using the MOVE switch) and observe the film as
it exits the discharge. It should be well laminated (clear) and free of wrinkles. If wrinkles are observed adjust
the tension controller knobs slightly on the film rolls. If the film is curled this could be an indication that the
tension of one of the film rolls is tighter than the other. Film must exit the machine flat, clear and free of
wrinkles before being put into automatic mode (pressing the START button). If there is curl during manual
mode there may be curl during automatic mode which will likely produce errors and possibly damage interior
components the machine.
