Fujiiryoki HWP-77EN, Instruction Manual

Page: 15 / 76

15
Method of
mounting
If there is any bulge at the tip end of
the water tap If the end of the water tap is straight and
not stepped
How to install a screw clamp
(If the corporation stop mounting accessories
of 16mm, 17.5mm and 19mm cannot be used)
Pass the corporation stop
tightening cap
through the pipe.
Insert the fixing ring to
the end of the pipe.
Apply the corporation
stop to the water tap
horizontally and tighten
the corporation stop
tightening cap.
Use the backing of the corporation stop
mounting accessory to measure the diameter
of the pipe and select a fixing ring to be used.
Backing of corporation
stop mounting accessory
Corporation stop
tightening cap
●
※ No screw clamp is packed together with this
product. Place an order with the store where
you purchased this product.
Direct the cutout of the fixing ring
toward you so as to easily insert.
Cutout
●
Do not use any tools to mount the corporation
stop tightening cap. (Breakage may result.)
Loosen the screw and set
the corporation stop
horizontally, and tighten
the screw while pressing
it against the water tap.
Do not excessively
tighten the screw.
(The water tap may
be perforated.)
Remove the screw
and pass the fitting
through the
corporation stop
tightening cap.
Mount the
screw again.
Corporation
stop tightening
cap
●
●
Fitting
●
Screw
●
Screw
●
Corporation stop
tightening cap
Tighten the corporation stop
tightening cap.
CAUTION