FujiFilm FinePix E 500, Service Manual

Page: 39 / 83

39
4. Adjustment
FinePix E500 Service Manual
<Step 4>
—> The [Firmware version check] screen appears.
<Step 5>
—> The [Adjustment Items Select] screen appears.
<Note>
(1) [F1] Battery Adjustment cannot be run unless the Fx-E500 Batt. jig is used to supply power to the camera.
(2) When new SUB PWB ASSY is replaced, SUB PWB ASSY is automatically initialized. At that time, wait for one-two
minutes, and advance the adjustment according to the instruction of the adjustment software.
FinePix E500 Jig Mode Setup Procedure
1. When execute the LCD adjustment, Set the VIDEO output
to the NTSC mode before starting the adjustment software.
2. When adjusting the [battery voltage],
supply power (3.0+-0.02V) by using [FX-E500 Battery JIG].
3. When executing the other adjustment,
supply power (3.0+-0.02V) by using [Power cable jig].
1). Open the battery cover.
2). Connect the power cable jig with the camera.
3). Adjust the output current of the power supply to 2.5A or less.
4). Adjust the output voltage of the power supply.
5). Connect the USB cable with the camera and PC.
6). Switch-ON the camera power while pressing the shutter button.
7). Check that the LED at the under the viewfinder
is lights in green.
Press the [Enter] key after completing the procedure of (1)-(7).
<Fig. 4-7-3>
FirmWare = 1.53
Vendor Name =FUJIFILM
Manufacturer =FUJIFILM
ProductName =FinePix
Device Type
=CAMERA
SerialNo =Y-701^^^^^040707C0PX0000000001
Frame Work =1.00
Please download a new version if it is necessary
to download the firmware.
Advance to the adjustment item selection screen
when press the [Enter] Key of PC.
<Fig. 4-7-4>
z
Revised: 24. Oct. 2005
z