FujiFilm FinePix E 500, Service Manual

Page: 37 / 83

37
4. Adjustment
FinePix E500 Service Manual
Menu Command Details
Operation Start Program start
Stop Program stop
Temporary stop Temporary program stop
Step 0
Do not use
End Terminate program
Program Reload Program (*.ff) reload
Select Program (*.ff) select
Edit Program (*.ff) edit
Data ad[ ] Do not use
rd[ ] Do not use
SW Do not use
fsw Do not use
EVR Do not use *1)
Mode File record Do not use
NGSTOP Program stopped if
adjustment is NG
STEP Do not use
LINE Do not use
AUTO Do not use
Setting OKNG clear Do not use
Mode set Sets up mode
Automaticadjustment Execution setting for Auto
Adjust in user program
Help Help Basic software help
FF help User program help
Focus Not used with this
adjustment software
Version Version information for
basic software
<Table> FFW.exe Commands
Cautions When Adjusting
*1) FinePix E500 cannot adjust the EVR data reading and
writing.(Details are right tables.)
*2) End Setting returns the camera from the Jig mode to
the Product Mode.
End Setting is required when using the PC
adjustment software, even when replacing boards or
units other than those noted above. Failure to run
End Setting will prevent identification as Mass
Storage.
When the camera is connected to the PC, and
prevent communication with the PC.
*3) When all adjustment have been completed, always
check that the camera is identified as Mass Storage.