FujiFilm FinePix 6800 Zoom, Owner'S Manual

Page: 62 / 67

123 122
Problem Cause Remedy Problem Cause Remedy
Troubleshooting
I can’t format the
SmartMedia. • The SmartMedia is write-protected. • Remove the write-protection.
(Peel off the write-protect sticker.)
The ERASE ALL function
does not erase all the
frames. • The frame is protected. • Remove the frame protection.
Nothing happens when I
use the camera switches
and dial. • Camera malfunction.
• The Mode switch and Mode dial has been
moved to another setting.
• The battery exhausted.
• Remove the battery, re-insert them and
try again.
• Set the Mode switch and Mode dial to the
correct setting.
• Load a new fully charged battery.
No image appears when I
press the, “DISP” button. • The Mode switch and Mode dial has been
moved to another setting.
• Set the Mode switch and Mode dial to the
correct setting.
The camera does not
emit any sound. • The camera volume is set too low.
• The microphone was blocked during
shooting/recording.
• The A/V cable is connected.
• Adjust the volume.
• Take care not to block the microphone
during shooting/recording.
• Disconnect the A/V cable.
There is no picture on
the TV. • The camera and TV are connected
incorrectly.
• The TV input is set to “TV”.
• Connect the TV and camera correctly.
• Set the TV input to “Video”.
PC connection failed.
• The camera and cradle are not connected
correctly.
• The USB cable is not connected to the
cradle correctly.
• The camera and USB cable are not set up
correctly.
• The PC is not switched on.
• Connect the camera and cradle correctly.
• Ensure that the USB cable is properly
connected to the cradle.
• Set up the camera and USB cable
correctly.
• Switch the PC on.
The lens extends during
card reader connection. • The camera and cradle are not connected
correctly.
• The PC is not switched on.
• Connect the camera and cradle correctly.
• Switch the PC on.
I tried to charge the
battery but the self-timer
lamp does not light. • There is no battery in the camera.
• The camera and cradle are not connected
correctly.
• The cradle and AC power adapter are not
connected correctly.
• Load the battery.
• Connect the camera and cradle correctly.
• Connect the cradle and AC power adapter
correctly.
The self-timer lamp blinks
during battery charging. • The battery is old. • Use a new battery.
The camera no longer
works correctly. • The camera has suffered an unforeseen
problem.
• Remove the battery briefly and then
reload the battery and try again.