Main Body
Please unplug the AC power cord before maintenance.
(It may cause electric shock and injury.)
Unplug
Warning
How to install the front filter
How to turn off the indicator
Clean with soft cloth.
Clean it with cloth soaked
with water or warm water
(below 40
ഒ
).
When it is very dirty
Avoid using the following items.
dz
Do not dismantle, modify and repair the device.
High voltage components are built in the device
and it is dangerous if you touch it.
Warning
After plugging in the AC power cord, please press the power
button and hold it until the indicator is off (approximately over 3 seconds).
21
①
②
Put back the front filter to the original position inside the air inlet. Slide it in with the
help of two fingers pushing at two corners of the filter until it fits in.
In case you find it difficult to fit it in, try to relax and let it fall back a little bit, and then
slightly lift it up and push it back slowly. When it fits to its place, you will hear a click
sound to confirm it is fixed (same applies to left and right sides).
They may damage the surface and the liquid may
penetrate into inner parts (precision parts). Such
may cause failure.
ɜ
ɜ
ɜ
ɜ
ɜ
ɜ
ɜ
ɜ
ɜ
Thinner
Benzene
Alcohol
Oven cleaner
Cleanser
Bleach
Synthetic detergent for home use (alkaline)
Spray-type detergent
Metal scrubbing brush
Filter reset
Press & Hold
Button
Troubles Shooting
Trouble
Please check
Stop operating
“Gee” noise is heard
Hard to get rid of odor
The indicator on
the top of the power
button is on or flashing.
If the main body
is dropped
ɡ
ɡ
:
ɡ
:
21
ɡ
Check if the AC power cord’s plug firmly plugged in.
Is the indicator’s light flashing (on and off)?
Ȫ
Reasons
ȫ
Ȫ
Flashing pattern
ȫ
dz
Fan motor error
dz
Ionizer error
dz
Ultra-violet lamp error
Ultra-violet lamp inside photocatalyst filter
and main body may be damaged.
Reference
page
*This product is equipped with ultra-violet lamp for enhancing deodorization and bacteria elimination.
In general, the lamp will last for more than 30,000 hours.
*Avoid watching at the light of ultra-violet lamp for a long time.
It is the operating sound of built-in components but
not an error noise. The interval and volume of the
sound may vary according to the operating condition
but it will not affect the performance of “MaSSC”.
Check if dust clogs the front filter.
!!
Please clean the front filter.
In case a large amount of odor is absorbed, the power
to resolve odor may temporarily decrease.
Let the device operate in a clean room for around 8
hours and the resolving power will recover.
Is the indicator’s light on (no flashing)?
This is the indication for cleaning. Please follow the
instructions on page 9 to clean the front filter. Press
and hold the power button (over 3 seconds) and the
indicator light will be off.
This is an error. Unplug the AC adaptor and
contact the shop where the device is purchased or
consult Shun Hing Technology Co. Ltd.
(Hotline: 23130666)
If the ultra-violet lamp damaged, the indicator will
flash (red) and stop operating. Please consult
Shun Hing Technology Co. Ltd. (Hotline: 23130666)
22
