Fuji Micro Genforce Baumr-AG BM-700i User Manual Download Page 18

Page: 18 / 30

Petrol Powered Inverter Generators

E&OE

DC Applications

Observe the following safety precautions when powering low voltage DC devices and

charging batteries

• When connecting a battery to the DC output, ENSURE that the polarity (

and

–

) of connections is

correct. Failure to do so may represent an explosion hazard and/or damage the generator and/or connected

battery. • The DC circuit is not monitored and does not automatically switch off or self-regulate depending on

the voltage of the connected battery. This means that you must independently monitor battery charge status

and disconnect the battery before it is over-charged. Over-charging batteries may present an explosion

hazard. • The DC output over-current protection can be tripped in the event of too much current being drawn

(see

Specifications

for maximum current draw for differing generator models). If this occurs, the DC

protection reset switch (on the control panel) will "pop out". Press the switch to reset the protection and re-

activate the generator DC output. • To prevent sparking near the generator, when disconnecting a battery,

disconnect the battery charging cable from the battery terminals before unplugging it from the generator DC

output socket. Disconnect the

negative

(

) terminal first, followed by disconnecting the

positive

(

) terminal

and do not allow the cable ends to touch. • When charging a battery that is mounted in a vehicle, at the

vehicle battery, disconnect the

negative

(

) terminal first, followed by disconnecting the

positive

(

) terminal.

Then, proceed to connect the battery charging cable as normal. Ensure that the battery terminals or charging

cable terminals do not make contact with the vehicle chassis as sparking may occur. • Do not attempt to start

a vehicle whilst its battery is connected to the generator, as damage to the generator may result. • Batteries

that are being charged may emit dangerous gases. Batteries being charged should be in a well ventilated

area and a safe distance from any sources of flame, heat, flammable or volatile materials. • Batteries contain

sulphuric acid. Contact with skin or eyes may cause burns – wash with water immediately (at least 15

minutes if has contacted eyes) and seek professional medical attention. Wear protective clothing and face

mask when handling batteries. • If battery acid is swallowed, administer water or milk and immediately seek

professional medical attention. • All batteries should be kept out of reach of children.

12VDC and 5VDC Devices

Some generators feature a protected 12VDC and or 5VDC

"USB" outlets that are used for powering suitable devices.

The 5VDC is "pure sine wave", allowing it to be used with

"sensitive" devices, such as laptop computers etc.
1. Start the generator.

2. Ensure that any device to be connected is switched

OFF, then plug the device/adapter in to the generator

12VDC outlet (

) (if applicable), or 5VDC USB connector (

) (if applicable), as required.

3. Switch the connected device ON and operate as normal.

4. When finished using the device, switch it OFF, then unplug the device from the generator.

Battery Charging

Some generators feature a protected 12VDC outlet

that is used for charging suitable batteries (vehicle

batteries etc). Use the supplied cable to connect

the battery to the generator.
1. Connect the battery charging cable (

) to the

generator DC output socket.

2. Connect the battery charging cable to the

battery terminals –

red

(

) to the battery

positive

(

) terminal,

black

(

) to the battery

negative

(

) terminal. Connect the

positive

(

) terminal first.

3. Start the generator.

4. When finished using the DC output, disconnect the battery charging cable from the battery, then

disconnect it from the generator.

FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG FUJI-MICRO GENFORCE BAUMR-AG