FuelTech FTSPARK 1500mJ, Owner'S Manual

Page: 9 / 44

9
FTSPARK
Pin Wire Label Function
1 Orange COIL A (+)
Coil primary output. High voltage (Positive side)
2 Orange COIL B (+)
3 Orange COIL C (+)
4 Orange COIL D (+)
5 Orange COIL E (+)
6 Orange COIL F (+)
7 Orange COIL G (+)
8 Orange COIL H (+)
9 Yellow Energy level
Energy level selection; (ground trigger)
NOTE: If the FTSPARK is connected via the CAN network, it
is not necessary to use this wire.
10 Yellow/Blue -- Wiring harness CANBUS CAN LOW
11 Yellow/White -- Wiring harness CANBUS CAN HI
12 Red Switched 12V FTSPARK Switch ON/OFF
13 Orange/Black COIL A (-)
Coil primary output. Wire 750V. Twisted. (Power ground side)
14 Orange/Black COIL B (-)
15 Orange/Black COIL C (-)
16 Orange/Black COIL D (-)
17 Orange/Black COIL E (-)
18 Orange/Black COIL F (-)
19 Orange/Black COIL G (-)
20 Orange/Black COIL H (-)
21 Black -BAT
Power ground. Connect to battery 22 Black -BAT
23 Black -BAT
24 Gray Ignition Input A Ignition trigger input A or Serial bus (1 wire)
25 Gray Ignition Input B Ignition trigger input B
26 Gray Ignition Input C Ignition trigger input C
27 Gray Ignition Input D Ignition trigger input D
28 Gray Ignition Input E Ignition trigger input E
29 Gray Ignition Input F Ignition trigger input F
30 Gray Ignition Input G Ignition trigger input G
31 Gray Ignition Input H Ignition trigger input H
32 Black GND Battery ground. Trigger signal reference
33 Red +BAT
Power supply for FTSPARK. Connect to battery positive or
main switch when required.
34 Red +BAT
35 Red +BAT
5.3 Harness connections table
750mJ connection table