20
FTSPARK
FTSPARK-4 managed by other aftermarket ECU’s
Bobina H
Bobina A
Bobina A
ABC
ABC
ABC
ABC
ABC
ABC
ABC
ABC
Cylinder #1
C
#2
ylinder
C
#3
ylinder
C
#4
ylinder
Fus 50A
e
FTSPARK-4
A
A
Battery Ground
Signal Reference
(
)
Power
Supply
12V Switched (FTSPARK activation)
Battery Ground
(Power Ground)
Ignition
Switched
Energy level
operate with minimum energy
- Connected or supplying 12V will make FTSPARK
ing (0V) will make FTSPARK
Ground
operate with maximum energy
ECU
ECU
Orange/Black wire
(GND from FTSPARK)
Orange wire
(+12 pulse from FTSPARK)
Coil GND
Ignition input #A
Ignition input #B
Ignition input #C
Ignition input #D
1st cylinder on firing order
2nd cylinder on firing order
3rd cylinder on firing order
4th cylinder on firing order
ABC
ABC
Ignition pins assignment
After FTSPARK installation, follow the steps
below if changes on the ignition outputs are
needed:
1 - Open the map on FTManager
2 - Click on “Sensors and calibration /
Outputs”
3 - Check which gray outputs are set as
ignition outputs. If you need to change
output order, proceed to step 4
4 - Click on “Engine settings / Advanced map
options”
5 - Click on “Ignition pins assignment
mode and change it from “Automatic” to
“Manual”
6 - Return to the “Sensors and calibration /
outputs” menu and change the ignition
outputs according to your installation
