www.fubag.ru
O
m
perator's
anual
6. Generator use
- To prevent electrical shock from faulty appliances, the generator should be
grounded. Connect a length of heavy wire between the generator's ground
terminal and an external ground source.
- Connections for standby power to a building's electrical system must be
made by a qualified electrician and must comply with all applicable laws and
electrical codes. mproper connections can allow electrical current from the
generator to backfeed into the utility lines. Such backfeed may electrocute
utility company workers or others who contact the lines during a power
outage, and when utility power is restored, the generator may explode, burn,
or cause fires in the building's electrical system.
- Limit operation requiring maximum power to 0 minutes. For continuous
operation, do not exceed the rated power. In either case, the total wattage of
all appliances connected must be considered.
- Do not exceed the current limit specified for any one receptacle.
- Do not connect the generator to a household circuit. This could cause the
damage to the generator or to electrical appliances in the house.
- Do not modify or use the generator for other purposes than it is intended for.
Also observe the following when using the generator
Do not connect generators in parallel;
Do not connect an extension to the exhaust pipe.
- When an extension cable is required, be sure to use a tough rubber
sheathed flexible cable.
- Limit length of extension cables; 60m for cables if 1 5mm and 100m for
cabes of 2 5mm .
- Keep the generator away from other electric cables or wires such as
commercial power supply lines.
- The DC receptacle can be used while the AC power is in use. if you use both
at the same time, be sure not to ex-ceed the total power for AC and DC.
Most appliance motors require more than their rated watt-age for start-up.
I
1
:
,
,
-
2
2
WARNING!
- 12 -
www.fubag.ru
Summary of Contents for TI1000
Page 1: ...www fubag ru ...
