Fubag B4000B/100 CM3, Operator'S Manual

Page: 8 / 20

Not to do:
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
- P
- A
-
-
-
Never direct the jet of air towards persons, animals or your body. (Always wear safety
goggles to protect your eyes from flying objects that may be lifted by the jet).
Never direct the jet of liquids sprayed by tools connected to the compressor towards the
compressor.
Never use the appliance in your bare feet or with wet hands or feet.
Never pull the power cable to pull the plug out of the socket or to move the compressor.
Never leave the appliance exposed to adverse weather conditions (rain, sun, fog,
snow).
Never transport the compressor with the reservoir pressurized
Never weld or machine the reservoir. In the case of faults or corrosion, replace it
completely.
Never allow inexpert persons to use the compressor. Keep children and animals away
from the work area.
Never position flammable or nylon or fabric articles close to and/or on the compressor.
Never clean the compressor with flammable liquids or solvents. Clean with a damp cloth
only, after making sure that you have unplugged the compressor.
The compressor is designed only to compress air and must not be used for any other
type of gas.
The compressed air produced by the compressor cannot not be used for
pharmaceutical, food or hospital purposes except after particular treatments. It is not
suitable for filling the air bottles of scuba divers.
Never use the compressor without guards (belt guard) and never touch moving parts.
To avoid overheating of the electric motor, this compressor is designed for intermittent
operation as indicated on the dataplate (forexample, S3-50 means 5 minutes ON and 5
minutes OFF). In the case ofoverheating, the thermal cutout of the motor trips,
automatically cutting off the power when the temperature is too high due to excess
current takeoff.
To facilitate machine restart, it is important not only to carry out the operations indicated
but also to set the button of the pressure switch, returning this to the OFF position and
then ON again (figures 1a-1b).
ress the reset button on the terminal box of themotor (fig. 2).
re fitted with a pressure switch equipped with a delayed closing air vent valve (or with a
valve located on the check valve) that facilitates motor start-up; therefore a few-second
jet of air from this, with the reservoir empty, is to be considered normal.
To guarantee machine safety, all the compressors are fitted with a safety valve that is
activated in the case of failure of the pressure switch (fig. 4).
When connecting an air-powered tool to a hose of compressed air supplied by the
compressor, interruption of the flow of air from the hose is compulsory.
Use of the compressed air for the various purposes envisaged (inflation, air-powered
tools, painting, washing with water-based detergents only, etc.) requires knowledge of
and compliance with the rules established for each individual use.
www.fubag.ru
O m perator's anual
- 7 -