Fuba
4
1.3.3
Programming the TV buttons
1.3.3.1
Changing TV code
Default TV codes are in the list attached to these instructions (see Appendix A). First identify the make of the TV you
want to control, then follow the steps listed below:
1.
Turn on the TV you want to control.
2.
Hold the TV button for about 2 seconds until the LED indicator on the remote control turns on.
3.
Enter the 3 digit code that corresponds to the brand of your TV to be controlled using the number keys 0÷9.
4.
If the code entered is valid, the LED will turn off. Otherwise, if it is the wrong code, it will Flash a few times before
turning off and, if so, the program will exit (restart from point 1).
5.
Verify that the TV responds properly when buttons are pressed on the remote, at least to the basic functions. If not,
press the TV programming button using another code among those on the list dedicated to the brand of your TV set
(resume from point 2).
If your brand is not on the list or none of the default codes allows you to control your TV, try to identify or define an
appropriate program using the method described below.
1.3.3.2
Manual search of TV code
1.
Turn on the TV you want to control.
2.
Point the remote control at the IR sensor of the TV and keep it pointed during the whole procedure..
3.
Hold the TV button for about 2 seconds until the indicator LED on the remote control turns on.
4.
Press sequentially one of the following keys:
q
, CH+, CH-.
5.
As soon as the TV responds appropriately to the command by turning off or changing the channel (in line with the
button pressed), press OK to store the code. The LED will then turn off.
Verify that the TV responds properly to the pressure of other remote control keys, at least within the limits of the basic
functions. If it does not, continue the search for an appropriate code by repeating the procedure (resume from point 2).
1.3.4
Using the remote control
After programming the remote to control your TV, it will work as your original remote with the TV at least limited to basic
functions such as turning on and off, adjusting the sound volume and changing channels.
To control the decoder or TV, with a single short push press the corresponding function keys STB (set top box) or TV
(television) and point the remote control at the IR sensor of the device in question. Upon the submission of each infrared
command, the remote control LED indicator will light up.
