FSR
MDC – MK1 Operations Manual [
Page 10 of 28
]
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
If you like the new settings, use the multi-button features described earlier to remember the settings
in Non-Volatile Memory. Holding the appropriate button allows fast increasing & decreasing.
Out H – Center: altering the display's left / right position
This adjusts the horizontal position of the computer image on the screen. Increasing the value (+
button) moves the display to the right, decreasing it (- button) moves it to the left.
Out H – Width: altering the display's width
Press the + button to increase the width of the picture and the - button to decrease it.
Out V – Center: altering the display's vertical screen position
Press the - button to move the picture up and the + button to move it down
Out V – Height: altering the display's height
Press the + button to increase the picture height and the - button to decrease it. You can return to the
previous menu by pressing the + button when the 'Exit' message appears.
5.4 Zoom
Zoom allows you to view a section of the video picture at twice the normal size. Panning in the zoom
mode allows you to select exactly what part of the screen is displayed. Note that:
§
Again, it is highly recommended that the user should have already run the AutoSet routine, so
that the unit knows exactly where the start and end of the computer image is within the incoming
computer signal. Otherwise, the user may be able to pan to areas of the computer image that are
completely empty.
§
The Panning settings are remembered when Zoom is subsequently turned off. This could be
useful in training applications.
§
It is possible to make the unit start up (from power on) in Zoom mode, and in a particular pan
position. This may be useful for certain applications, and is done by using the special multi-hold
buttons described earlier.
Enter the Zoom... sub-menu by pressing the + button when this message appears
.
Zoom - turning on and off
Press the + button when 'Zoom Off' is displayed to turn the zoom on and the - button to turn the
zoom off again. Pressing MENU will move to the options to alter the panning position.
Pan X Position - adjusting the horizontal panning position
Press the - button once to pan left one step (i.e. move the zoomed image to the left). Similarly, press
the + button once to pan right one step.
Pan Y Position - adjusting the vertical panning position
Press the + button once to pan down one step. Press the - button once to pan up one step.
Press + when the 'Exit' message is displayed to exit this sub-menu. However, zoom will still be active
until disabled.
