[17]
Water Chiller Upgrade (Optional)
The water chiller replaces the water pump. If your laser is shipped with a water chiller then the
pump is normally not included. Unscrew the cap at the top of the water chiller and fill with
water.
The basic radiator style chiller (Figure 9) takes approximately 3-5 gallons of distilled water; the
advanced freon chiller requires 1-2 gallons.
Figure 9 - Basic Water Chiller
Connect the water
OUTLET
on the water chiller to the water inlet of the laser. Connect the
water
INLET
on the water chiller to the water outlet on the laser. Turn the water chiller on and
the water will be flowing. The other buttons on the advanced freon chiller adjust the
temperature and do not need to be adjusted. The ideal temperature for the water is between
55-80 degrees.
Air Assist
Air is used as a pressurized gas to assist in cutting and engraving operations. The pressurized
air is critical to safe and efficient cutting operations as it not only helps cut through material,
but also helps prevent the formation of flames. The air assist connection is a barbed brass
fitting located on the rear of the laser.
