EN
5
1. Wind 2 layers of insulation tape on protective coat of fiber core for protection. Meanwhile, get rid of
the stuffing to separate fiber core and clean them. Form a ring with the diameter of 100mm or so and
fix it on the fiber temporarily by adhesive tape.
2. Depending on fiber cable stripped, the following two cases are available
：
①
All fibers are to be branched after being spliced completely.
②
Some of fibers are for straight-through after being winded, while the others are for branch splicing.
3. The FOSC is provided with 3 single entry/exit tubes which suit for single fiber cables with max.
diameter ф20mm and 1 mass entry/exit tube which suits for 1piece of fiber cable with max. diameter
ф 20mm or 2 pieces of fiber cables with max. diameter ф 15mm or multi-pieces of fiber cables with
short diameter.
4. Mass entry/exit tube is required if some fibers are for straight-through.
5. The corresponding entry/exit tube cover could be slightly knocked out with screwdriver from
inside to outside according to number and diameter of fiber cable required.
6. Reserve reinforced core in 70mm length and cut off the unnecessary ones.
NOTE:
Entry/exit tubes are to be selected accurately to make it easy for splicing and sealing.
Separate Fiber Cores
Adhesive tape
Reinforced core
70mm
Fiber with
protective coat
Fiber cable (1)
Fiber cable (2)
Fiber cable (3)
Fiber
Fiber with
protective coat
Adhesive tape
Adhesive tape
Fiber
Straight-through fiber
with protective coat
Fiber
Reinforced core
