frozy FR25 SI, User Manual

Page: 13 / 20

Chapter 05. Cleaning and Maintenance of Your Ice Maker
Safety rules must be observed before cleaning your Ice Maker:
1. Unless otherwise specified, turn off and unplug the unit before starting to
clean the Ice Maker.
2. The outer casing of the product should only be cleaned by wiping with a
damp cloth. Do not spray the unit with water or any other cleaning solvent.
This causes undesired electrical failures and jeopardizes the safety of the
user.
3. Always wear protective gloves and similar protective equipment during
cleaning.
4. Never use cleaning agents and chemicals which may cause cutting, piercing
and corrosion to your product. Your Ice Maker will be out of warranty if
chemicals are used for cleaning.
5. Do not use any cleaning agents not recommended by your Authorized
Service.
Exterior Cleaning of the Ice Maker
The exterior of your ice-maker is made of stainless steel. Wipe the exterior surfaces
with a cotton damp cloth or a sponge and then wipe it with a dry, clean cotton cloth.
Cleaning of the Sprayer System
1. Make sure the water and electrical connections of the product are off, in
compliance with the cleaning instructions above.
2. Remove all the ice from the storage bin.
3. The power switch should be off, and the water inlet valve should be opened.
4. Remove the wire located inside the pool and then remove the level discharge
plastic from its slot, and ensure the water to be discharged. (See Figure-3)
5. Place the level discharge plastic back to its slot after discharging the water
inside the pool. (See Figure-4)
6. Then, pour the cleaning solution recommended by Authorized Service into the
water pool.
7. Select the ‘cleaning’ setting on your product, then turn the power switch to the
“On” position. WITHIN 30 SEC OF TURNING ON THE POWER, YOU MUST PRESS
AND HOLD THE ‘CLEANING’ BUTTON FOR 8 SEC. (See Figure-5)
8. The cleaning process will continue for 10 minutes.
9. At the end of the cleaning cycle, remove all the produced ice from the storage
bin.