frozy FR25 SI, User Manual

Page: 10 / 20

Chapter 03. Installation of Ice Maker
Selection of Location for Your Product
Your product should not be in direct contact with or in close proximity to any heat
source.
You should leave at least 10 cm of distance if you place your ice maker next to
other electrical equipment (such as ovens, computers etc,) that are considered as
heat sources.
If the product is to be placed next to a wall, the distance between the back surface
of the product and the wall should not be less than 20 cm (See Figure-7).
Do not place objects in front of the ventilation filter of your ice maker that might
prevent air circulation into your product.
Do not place your product outdoors. This product is designed to be used indoors.
Electrical Connection
The voltage and frequency values of the main power supply have to be the same
as written on the product label. If you are in doubt or need assistance, please
contact the nearest Authorized Service or get help from a qualified electrician.
Make sure your power outlet has been grounded.
The amperage of the circuit breaker to which the product will be plugged in should
be 10A**. (See Technical Table / Entry fuse section.)
Do not use power strips with multi sockets or extension cords to operate your
product.
Water Use and Connection
Your ice maker is designed to make ice cubes within the most ideal time and size.
However, it is important to note that there are some things that will affect the
quality of the ice produced by the machine, as well as the health of the internal
components of the ice maker.
The Main Water Supply
Should be good for human consumption,
Should have an optimum level of hardness,
Should include minimal amount of chlorine.
The optimum water filters to be used on your product are available and can be
purchased from your Authorized Service.
Water temperature should be between 10°C and 30°C