Be sure that you are thoroughly familiar with the assembly and installation process
before turning on your kegerator.
IMPORTANT!
You should position your unit in an upright position and allow to sit for
at least 8-10 hours before plugging into an outlet. This will allow any refrigerant that
has moved to settle back to where it should be before operation.
1
.
Your kegerator is shipped in double-walled cardboard for maximum protection
(Figure 1). Remove this cardboard carefully. You may wish to leave the bottom
cardboard panel beneath the kegerator to protect flooring when assembling
guardrail, tower, tank and casters.
2. Your kegerator is also shipped with a protective plastic lining (Figure 2) on
the door to protect it during assembly. To prevent scratches or accidental
blemishes during the assembly process we recommend leaving this
coating on until assembly is complete.
3.
The unit is shipped ready for refrigerator use (Figure 3) with shelves in place. To
use as a refrigerator simply remove the packaged parts and the keg board,
insert the beer tower plug (see page 5 for parts list), adjust the temperature
settings, and after allowing ample time for the refrigerant to settle after shipping,
plug in the unit. To assemble as a kegerator follow the rest of the assembly steps
in this manual.
4.
Remove shelves, shelf rack and packaged parts from the kegerator cabinet.
Unpack the parts and consult page 5 to become familiar with all assembly parts.
Note: your unit ships with several extra washers; please be sure to keep these in
a safe place with the manual in case you should ever need them.
1
.
To install the casters (page 5, F), first make sure everything is removed from the
kegerator cabinet, then tilt the front side of the unit
back slightly on a dry and padded surface. Do not tilt
more than 30 degrees when installing casters to avoid
jostling any refrigerant.
2.
Install casters into holes on bottom of kegerator as
shown in Figure 4 and tighten with a 3/8” wrench (not
provided). Two of the four casters provided are
equipped with locks to prevent slipping of the keg on
smooth surfaces such as hardwood floors, linoleum or
tile.
These casters should be installed on the front
of the unit. IMPORTANT! Casters should be
installed with wrench to prevent breakage!
3.
Once all 4 casters are attached return the kegerator to
an upright position and allow to remain for at last 8-10
hours (see
Note
above).
Copyright 2010 DTX International
UNPACKING YOUR KEGERATOR
REMOVING PACKAGING
Figure 1
Figure 2
Figure 3
KEGERATOR ASSEMBLY
CASTER ASSEMBLY
Figure 4
7
