Copyright 2010 DTX International
12
KEGERATOR OPERATION
1.
To begin using your kegerator you will need to attach the
to the keg. First, after double-checking to ensure that the silver end of the CO line
2
has a washer installed and that the keg coupler’s CO connection’s hat-shaped
2
washer is in place, attach the silver end of the CO line to the CO connection on
2
2
the keg coupler (
Figure V
). Hand tighten securely.
2.
Next, connect the beer line to the top of the keg coupler, making sure that the beer
line coming down from the tower has a washer-gasket installed (
Figure W
). Hand
tighten securely.
3.
With both lines firmly connected to the keg coupler, finalize the connection by
pulling the black tap handle out (
Figure X
) and pushing down until it clicks securely
(
Figure Y
). There will be an audible click, signaling that the CO and beer connec-
2
tions have been opened and that your keg is tapped.
4.
Next turn the red
lever
on the CO regulator so that it is inline and parallel with the
2
CO line (
Figure Z
). Open the CO tank valve 1/4 to ½ turn to the left, then slowly
2
2
engage the CO by turning the red pressure gauge knob to the right until the
2
regulator’s PSI gauge reads between 10-12 PSI (
Figure AA
).
Refer to the illustration below for a brief summary of the steps involved in preparing
the kegerator to keg connection.
CO line and the beer line
2
Figure W
Figure W
Figure X
Figure Y
Figure Z
Figure AA
