HOW TO REMOVE THE SNOW HOOD
To access the spark plug, the snow hood must be removed as
follows:
1. Remove the choke control knob (see Figure 27).
2. Remove the
safety key
.
3. Remove the
mounting screws
(see Figure 28).
4. Slowly remove the snow hood. Make sure that the
primer but-
ton hose
and the
ignition wire
are not disconnected.
5. The
spark plug
can now be accessed.
6. To install the snow hood, first make sure that the primer but-
ton hose and the ignition wire are connected.
7. Mount the snow hood to the engine and secure with the
mounting screws (see Figure 28).
8. Connect the choke control knob with the choke shaft on the
carburetor (see Figure 29 and Figure 30). Make sure the choke
control knob is properly installed. If the choke control knob is
not installed correctly, the choke will not operate.
9. Install the
safety key.
Figure 30
Safety Key
Carburetor
Figure 29
Choke Control Knob
Choke Shaft
Figure 28
Mounting
Screws
Ignition
Wire
Primer Button
Hose
Snow Hood
Spark Plug
Figure 27
Choke Control Knob
Safety Key
MAINTENANCE
26
Summary of Contents for ST7526
Page 1: ...OPERATOR S MANUAL SNOWTHROWERS ST7526 MT1735091 Rev 00 5 21 07 TP 100 4612 00 IS T...
Page 40: ...NOTES 40...
Page 41: ...NOTES 41...
Page 44: ......
