![Frontier ST7526 Operator'S Manual Download Page 19](http://html1.mh-extra.com/html/frontier/st7526/st7526_operators-manual_2339773019.webp)
How To Start A Cold Engine
1. Be sure auger drive and traction drive levers are in the disen-
gaged (
RELEASED
) position.
2. Push the
stop switch
to the ON position (see Figure 20).
3. Push in the
safety key
.
4. Rotate the
choke knob
to the CHOKE position.
5.
(Electric Start)
Plug the power cord into the
starter motor
on
the engine. Plug the other end of power cord into a three-hole,
grounded 120 volt, AC receptacle.
6. Push the
primer button
as specified below. Remove finger
from primer button between pushes.
• Push two times if temperature is 15° F (-9° C) or higher.
• Push four times if temperature is below 15° F (-9° C).
7.
(Electric Start)
Connect the power cord to the engine and
depress the starter button. To prolong the life of the starter, do
not crank for more than 5 seconds at a time. Wait one minute
between starts to allow the starter motor to cool.
8.
(Recoil Start)
Slowly pull the
recoil starter handle
until
resistance is felt and then pull rapidly to start the engine. Do
not allow the
recoil starter handle
to snap back. Slowly return
the
recoil starter handle
.
9. If the engine does not start in 5 or 6 tries, see Difficult Starting
in the TROUBLE SHOOTING CHART.
10. Allow the engine to warm up for several minutes. As the
engine warms up, adjust the
choke knob
toward the RUN
position. Wait until the engine runs smoothly before each
choke adjustment.
11.
(Electric Start)
First disconnect power cord from receptacle.
Then, disconnect the power cord from the
switch box
.
If after following the preceding instructions, your engine fails to
start, have the engine checked by a John Deere/Frontier dealer.
NOTE: Do not lose the safety/ignition key. Keep the safety/igni-
tion key in a safe place. The engine will not start without the
safety/ignition key.
How To Start A Warm Engine
If restarting a warm engine after a short shutdown, leave the choke
lever in the off position and do not push the primer button. If the
engine fails to start, follow the Cold Start instructions.
OPERATION
19
Figure 20
Primer
Recoil Starter Handle
Safety Key
Stop Switch
Starter Motor
Starter
Button
Choke Knob
Summary of Contents for ST7526
Page 1: ...OPERATOR S MANUAL SNOWTHROWERS ST7526 MT1735091 Rev 00 5 21 07 TP 100 4612 00 IS T...
Page 40: ...NOTES 40...
Page 41: ...NOTES 41...
Page 44: ......