Operation
11
5WPMAN0148 (Rev. 5/16/2008)
Angling and Reversing
(Figure 5)
Ten holes are provided for angling the blade: five in the
forward position (to a maximum angle of 45 degrees)
and five in the reverse position. Lift the drop pins,
swing the blade to the desired angle or to the reverse
position, then reinsert the drop pins to lock the blade in
place.
Figure 5
. Angling and Reversing
Frame Offset
(Figure 6 & Figure 7)
The frame will swing to the right or left. For offsetting
the frame to the right, position the standard mechanical
linkage (1) on the left side of the frame.
1. Mechanical linkage
2. Centering pin
Figure 6
. Rear Blade Centered
Extend the linkage by pulling the center pin (2) and
swinging the frame to the desired angle. Lock the link-
age in place by inserting the pin in the desired hole.
Secure with hair pin clip. For offsetting to the left, posi-
tion the linkage on the right side of the frame and
extend the linkage.
Figure 7
. Rear Blade Offset Right
Blade Pitch
The pitch of the blade can be changed by adjusting the
top link of the tractor.
Blade Tilt
(Figure 8)
The blade will tilt so that one end of the moldboard is
lower than the other. Remove yoke pin (1), tilt the blade
to the desired angle, replace the pin, and secure with
the hair pin clip. Additional tilt adjustment can be made
with the tractor 3-point hitch leveling crank.
1. Yoke pin
Figure 8
. Blade Tilt
