Fronius VR 5000 noSpool, Operating Instructions Manual

Page: 82 / 132

82
Factory setting: Off
NOTE!
The "Ignition time-out" function (ito) is a safety function.
The length of wire that is fed before the safety cut-out trips may differ from the preset wire
length, particularly when the wire is being fed at fast wire feed speeds.
The "Ignition time-out" function (ito) is explained in the "Special functions and options" sec-
tion.
SPt Spot time - spot / stitch welding time
Unit: s
Setting range: OFF, 0.1 - 5
Factory setting: OFF
SPb Spot break - stitch pause time
Unit: s
Setting range: OFF, 0.1 - 10 (in 0.1 s increments)
Factory setting: OFF
FAC Factory - Reset power source to factory setting
Press and hold down the "Dynamic" (manual control panel) or "Parameter selec-
tion" (Synergic A control panel) button for 2 seconds to restore the factory settings.
When "PrG" is shown on the digital display, the power source has been reset.
IMPORTANT! When the power source is reset, all the personal settings in the Set-
up menu are lost. Operating points that were saved using the "Save" buttons are
retained when the power source is reset. The functions in the second level of the
Setup menu (2nd) are also not deleted. Exception: Ignition time-out function pa-
rameter (ito).
2nd Second level of the Setup menu (see "Setup menu - level 2")