Fronius VR 5000 noSpool, Operating Instructions Manual

Page: 75 / 132

75
EN
Saving and retrieving operating points
General The "Save" buttons allow up to 5 operating points to be saved. Every operating point
matches the settings on the control panel.
IMPORTANT! Setup parameters are not saved at this time.
Saving operating
points Press and hold one of the "Save" buttons to save the current settings on the control
panel, e.g.:
- The left indicator displays "Pro"
- After a short time, the left indicator switches to the original value
Release the "Save" button
Retrieving operat-
ing points To retrieve saved settings, press the corresponding "Save" button briefly, e.g.:
- The control panel will show the saved settings
Deleting operat-
ing points Press and hold the relevant "Save" button to delete the memory content of that "Save"
button, e.g.:
- The left indicator displays "Pro"
- After a short time, the left indicator switches to the original value
Keep the "Save" button held down
- The left display shows "CLr".
- After a while, both displays show "---"
Release the "Save" button
Retrieving operat-
ing points on the
Up/Down welding
torch One of the "Save" buttons on the control panel must be pressed to retrieve the saved set-
tings using the Up/Down welding torch.
Press one of the "Save" buttons on the control panel, e.g.:
- The control panel will show the saved settings
The "Save" buttons can now be selected using the buttons on the Up/Down welding torch.
Vacant "Save" buttons are skipped.
In addition to the "Save" button number lighting up, a number is displayed directly on the
Up/Down welding torch:
1
2
1
1
2
3
Number 1
Number 2
1