7
EN
Safety rules
Explanation of
safety symbols
If you see any of the symbols depicted in the "Safety rules", special care is required.
General
DANGER!
indicates immediate and real danger. If it is not avoided, death or se-
rious injury will result.
WARNING!
indicates a potentially dangerous situation. Death or serious injury
may result if appropriate precautions are not taken.
CAUTION!
indicates a situation where damage or injury could occur. If it is not
avoided, minor injury and/or damage to property may result.
NOTE!
indicates a risk of flawed results and possible damage to the equipment.
IMPORTANT!
indicates tips for correct operation and other particularly useful information.
It does not indicate a potentially damaging or dangerous situation.
The device is manufactured using state-of-the-art technology and according
to recognised safety standards. If used incorrectly or misused, however, it can
cause
-
injury or death to the operator or a third party,
-
damage to the device and other material assets belonging to the operat-
ing company,
-
inefficient operation of the device.
All persons involved in commissioning, operating, maintaining and servicing
the device must:
-
be suitably qualified,
-
have sufficient knowledge of welding
-
read and follow these operating instructions carefully.
The operating instructions must always be at hand wherever the device is be-
ing used. In addition to the operating instructions, attention must also be paid
to any generally applicable and local regulations regarding accident preven-
tion and environmental protection.
All safety and danger notices on the device
-
must be kept in a legible state
-
must not be damaged/marked
-
must not be removed
-
must not be covered, pasted or painted over.
For the location of the safety and danger notices on the device, refer to the
section headed "General remarks" in the operating instructions for the device.
Before switching on the device, remove any faults that could compromise
safety.
Your personal safety is at stake!
Summary of Contents for TransTig 1750 Puls
