NOTE!
A short circuit between the bare cleaning or print electrode and the workpiece can
impair the cleaning result, the print result, and/or the surface of the workpiece!
▶
Make sure that the cleaning or Print felt does not have any holes or chafed areas
▶
Push the cleaning or Print felt completely onto the cleaning or print electrode
▶
Make sure that the tip of the cleaning or Print electrode is completely covered by the
cleaning or print felt
▶
If necessary, always fix the cleaning or Print felt with an O-ring or rubber ring (see
also from page
onwards)
NOTE!
Cleaning felt or cleaning brush must always be soaked with cleaning electrolyte,
otherwise the service life will be reduced.
▶
If burns or cracks are visible on the cleaning felt or cleaning brush, replace them.
▶
Do not make contact between cleaning electrode and workpiece without cleaning
felt.
NOTE!
To prevent damage to the workpiece to be treated and burning of the cleaning felt
due to excessive cleaning power:
▶
Perform preliminary tests on material samples
▶
Always use sufficient cleaning electrolyte
NOTE!
An improper Print procedure can result in damage to the workpiece surface!
▶
During the Print process, make sure that the Print electrode is not in direct contact
with the workpiece.
The Print electrode may only be moved on the Print film.
▶
Do not mixPrint electrolytes.
▶
After performing the Print process, do not place the Print torch with the Print elec-
trode on the workpiece - place the print torch on the print torch holder or switch off
the device beforehand!
22
