Particular hazard
areas
Special regulations apply in areas at risk of fire or explosion
-
Follow the appropriate national and international regulations.
Devices for work in areas with increased electrical hazard (such as boilers) must be
labeled with the symbol [S] (Safety).
Measurements of toxic emissions when working with the device showed values below
permissible "average workplace concentrations" (MAK).
Nevertheless:
-
Ensure there is a sufficient supply of fresh air.
-
Keep your face away from any vapors that arise.
-
Do not inhale vapors, or extract vapors from the work area by suitable means.
During operation
-
Ensure that all covers are closed, and all side parts have been mounted properly.
-
Keep all covers and side parts closed.
If the device is equipped with a carrier belt or handle, then this is used exclusively for
transport by hand. The carrier belt is not suitable for transport by crane, counterbalanced
lift truck or other mechanical lifting tools.
Safety measures
at the setup loca-
tion and during
transport
A toppling device can be deadly! Set up the device securely on an even, solid surface
-
The maximum permitted tilt angle is 10°.
Special regulations apply in areas at risk of fire or explosion
-
Follow the appropriate national and international regulations.
Use instructions and checks within the company to ensure that the vicinity of the work-
place is always clean and organized.
Only set up and operate the device in accordance with the protection class shown on the
rating plate.
When setting up the device, ensure that there is an all-round clearance of 0.5 m (1 ft.
7.69 in.) to allow cooling air to circulate unhindered.
Take care to ensure that the applicable national and regional guidelines and accident
prevention regulations are observed when transporting the device, especially guidelines
concerning hazards during transport and shipment.
Before transporting the device, always completely drain the cleaning agent.
It is essential to conduct a visual inspection of the device to check for damage after it has
been transported but before commissioning. Have any damage repaired by trained ser-
vice technicians before commissioning the device.
Safety measures
in normal opera-
tion
Only operate the device when all safety devices are fully functional. If the protection
devices are not fully functional, there is a danger of:
-
Serious or fatal injury to the operator or third parties
-
Damage to the device and other material assets belonging to the operating company
-
Inefficient operation of the device
Safety devices that are not fully functional must be repaired before the device is switched
on.
Never bypass or disable protection devices.
Before switching on the device, ensure that no one can be put in danger.
10
