Fronius Datamanager 2.0, Operating Instructions Manual

Page: 35 / 88

Installing and connecting WLAN antennas
General Depending on the inverter the WLAN antenna must be either installed in the inverter or
mounted to the outside of the inverter.
IMPORTANT! Always follow the relevant operating instructions when opening an invert-
er! Observe the safety rules!
Fronius IG, Froni-
us IG Plus, Froni-
us IG Plus V,
Fronius CL: In-
stalling and Con-
necting Antennas
2
1
1
Use the double-sided adhesive tape to
fasten the mounting bracket to the out-
side of the inverter housing or, if suit-
able for the antenna cable, secure it in
a position near the inverter
IMPORTANT! The double-sided ad-
hesive tape only reaches its maximum
bond strength after 24 hours.
IMPORTANT! The mounting bracket
may not be screwed to the inverter
housing.
It may however be fitted in a nearby
position. The relevant screws are not
included in the scope of delivery and
must be selected by the installer.
0,9 Nm
1
2
2
Connect the antenna cable to the an-
tenna socket on the Fronius Dataman-
ager 2.0 plug-in card
3
Run the antenna cable out through the
DATCOM opening on the inverter
4
If possible, secure the cable with a
strain relief device
5
Close or seal the DATCOM opening in
accordance with the inverter operating
instructions
35
EN-US