1-10
Tool doesn’t weld
Welding gripper P32.1511 is dirty or
worn
Replace or clean welding gripper,
don’t use any hard objects for this
(see operation manual P328)
Welding stop gripper P32.8107 is dirty
or worn
Replace or clean welding stop gripper,
don’t use any hard objects for this
(see operation manual P328)
Damaged housing parts
Replace housing parts
Defective circuit board
Replace circuit board
Pressure spring N21.5138 defective
Replace pressure spring
Needle free wheeling N3.4509 in
P32.8139 defective or assembled
reversed
Assemble the needle free wheeling
correct or replace it
Gearing parts of the welding gear are
defective
Check welding gear and replace
defective parts
Gear motor N51.1127 defective
Replace Gear motor
Toothed belt N4.3236 or Toothed belt
pulley P32.8122 is worn
Replace Toothed belt or
Toothed belt pulley
Defective gear bearing
Replace bearing
Tool badly cuts the strap or
doesn’t cut at all
Cutter is worn or damaged
Replace cutter
(see operation manual P328)
Wrong adjustment of the coupler
P35.0146
Check adjustment and readjust if
necessary
(see operation manual P328)
Welding gripper P32.1511 is worn
Replace welding gripper
(see operation manual P328)
Welding time too short
Change adjustment
(see operation manual P328)
Defective pressure spring N2.5237
Replace pressure spring
Tool switches off after a few
strappings
(Displaying empty battery)
Battery defective or empty
Check the battery and change
defective batteries
Gear noise
Tensioning or welding gear is worn
Check component parts and replace
defective ones
SYMPTOM
CAUSE
REMEDY
Purchase at Allstrap (866) 779-2673