4. INSTALLATION STEPS
Step 1: Mount the system or set the system on the ground by using the
holders.
Option 1: Mount the system (onto a wooden plate)
Option 2: Set the system on the ground
03
Note:
Note:
Please always use plumber tape on threaded connection parts
to ensure a watertight seal.
Leave at least 2 inches higher than the ground for easier filter
replacement.
1. Find the proper place to mount up the
system.
1. Setup the holder on flat ground.
2. Insert the long side end of the wire into the upper hold of the holder.
Insert the other end into the base hole.
3. Make sure all the spring wires of the holder
stretch out steadily.
4. Set the system on the holders.
2. Srew off the cartridges.
3. Mount up the filter heads using the
provided screws.（Please use at least 6
screws to fasten the system.)
4. Scew back the cartridges.
Step 2: Connect the water hose
1. Connect the inlet hose to the
“lnlet” port.
Inlet hose
