pulverisette 16
Page 14
4.4 Inserting the bottom sieve
Bottom sieves
BS
of stainless steel with Conidur or round perforation
are available as accessories. (See image)
Conidur 0.12/0.2/0.25/0.5/0.75/1/1.5/2
mm
Round hole
3/4/5/6/8/10 mm
•
Stop the “pulverisette 16”
•
Open the mill housing
•
Insert the bottom sieve
BS
•
Set the impact gap between the grinding insert and cross beater
to 1mm, with a bottom sieve to cross beater spacing of not
< 1 mm.
•
Close mill housing
•
Make certain that a collecting vessel is in place.
•
Start the “pulverisette 16”
Important:
Never operate the device without a bottom sieve inserted! Risk of injury
through possible insertion of fingers from below!
4.5 Filter hose and collecting vessel
Through the use of a textile filter hose between the “pulverisette 16”
and the collecting vessel, the airflow generated by the rotating cross
beater is guided away and a back draft is prevented. In addition, it ac-
celerates the material throughput and ensures a gentle grinding proc-
ess.
*
Slide filter hose
E
over the flange, and at the same time hold
the clamping clip at an angle
*
Clamp on seal
E1
*
Hang in the collecting vessel
F
*
Clamp on seals
F1
If the collecting vessel is installed without filter hose, you can expect
dust to escape from the filling funnel
D
.
4.6 Adding material for grinding
The maximum grain size should not exceed 20 mm.
*
Add grinding material slowly into the filling funnel
D
(see im-
age)
A rebound blocker in the filling funnel prevents the grinding material from
being thrown back out.
