Fault Code
If the screen on the unit displays
“AS”, the room temperature sensor
has failed. Contact your Authorized
Frigidaire Service Center.
If the display reads "E4", the
communication between display
PCB and main control PCB is
faulty. Contact your Authorized
Frigidaire Service Center.
If the screen on the unit displays
“ES”, the pipe temperature sensor
has failed. Contact your Authorized
Frigidaire Service Center.
Emptying the condensate residue
inside the unit for the P1 message
or during winter storage. Refer to
the "Drainage Instructions" on
Page 21 for more instructions to
drain the successive condensate. If
error repeats, contact your
Authorized Frigidaire Service
Center.
21
OPERATING INSTRUCTIONS
Drainage Instructions
Continuous Drainage
During the Dry mode, you will need a garden
hose (sold separately) to drain the
condensate from the unit. Follow the steps
below:
•
Unscrew the drain cap of continuous drain
outlet(Fig.20).
•
Connect one end of the garden hose (sold
separately) to the drain outlet then lead
the other end into a drain that is lower
than the unit(Fig.21).
Drain cap for Dry
mode
Figure 20
NOTE:
• Condensate may flow out after removing
the drain cap, if the unit is running in Cool
or Auto mode. When you want to remove
the garden hose, prepare a drip tray (not
supplied) to collect the condensate from
the drain outlet.
• Please be sure that the height of the drain
and section of the drain hose should not
be higher than that of the drain outlet, or
the continous drainage may not work
properly.
• During Cool or Auto mode, it is
recommended to disable continuous
drainage by replacing the drain cap to the
drain outlet, to reach the maximum
performance.
Garden hose
Figure 21
During the Heat mode, you will need a 1/4"
drainage hose (packed with the unit) to
drain the condensate from the unit.
Follow the steps below:
Heat pump Drainage(For heating & cooling
model only)
• Unscrew the heat pump drain cap and
rubber of heat pump drain outlet(Fig.22).
Summary of Contents for FHPC102AC1
Page 27: ......