Frigidaire FHPC102AC1, Use & Care Manual

Page: 10 / 28

10
INSTALLATION INSTRUCTIONS
4.Drive two 1/2" screws to secure the
window slider kit to the window sash.(Fig.9)
5.Secure the window slider kit to the
window sill(Fig.9):
A: For wooden window: Use 3/4" screws for
securing.
B: For Vinyl-Clad windows: Use 1/2" hex
head cap screws for securing.
6.To secure lower sash in place, attach right
angle sash lock with 1/2" (12.7mm) screw as
shown(Fig.10).
2.Open the window sash and place the
window slider kit on the window sill (Fig.13).
Attach the window slider kit to the window
sill. Adjust the length of the window slider
kit according to the height of window.
Screw down the two screws on the window
slider kit. See Fig.13.
Cut the adjustable window slider kit if the
height of window is less than 26.6
inches(Fig.8).
Fig.12
Foam seal A
(adhesive type)
Fig.13
window sill
Window slider kit
screws
26.6"~52.5"
Fig.10
Fig.9
1/2"screws
3/4" screws or 1/2"
hex head cap screws
window sill
Window slider kit
7.Cut the non-adhesive foam seal (B) to an
appropriate length and seal the open gap
between the top window sash and outer
window sash, as shown in Fig.11.
1.Cut the adhesive foam seals (A) to the
proper lengths and attach them to the
window frame. See Fig.12.
Fig.11
Foam seal B
Installation in a sliding sash window
3.Close the window sash securely against
the window slider kit.(Fig.9)
Fig.8
Cut this to fit your window